1 Followers
25 Following
ravenmemory64

ravenmemory64

SPOILER ALERT!

1. Right-click the computer system initially, and after that pick management, as shown under:

2. Then enter, you'll be able to see the following picture. At present, only the solid state drive has partitions, and also the memory from the mechanical tough drive isn't allocated. This leads to that we can only see the strong state drive, but not the mechanical hard drive.
3. Click on the black unallocated location, then right-click and after that click New Very simple Volume
4. Click Subsequent
five. Then see the following picture. In the red box, enter the size in the partition you desire. The unit here is MB. If SanDisk SD Card deleted Video recovery want to allocate 100G of space, it needs to be one hundred * 1024 = 102400
six. Then assign the drive, that may be, you would like to be assigned towards the D drive, or other drive
7. Then, go directly for the subsequent step
8. Finally, click Finish to complete the partition. Within this way, you are able to see other disks within your laptop or computer. Repeat as lots of partitions as you would like to allocate.
9.
Note that a really hard disk can have 1 to three principal partitions and 1 extended partition, or it could only have a primary partition without extended partitions, but there should be no less than 1 key partition, and at most 1 extended partition, as well as the most important partition + extended There may be no much more than four partitions in total. There is usually many logical partitions.
As shown inside the figure beneath, the green area can be a logical partition. A lot of people prefer to get extra partitions. It is possible to have several partitions here.